560
|
Universiti Teknologi Malaysia |
Assoc. Prof. Dr. Mohamad Ali Fulazzaky |
Department of Environmental Engineering, Faculty of Civil Engineering |
Removal, Granular materials, Water Quality, Mass Transfer, Hydrodynamics, activated carbon, wastewater and mathematical models
|
|
-
Precipitation of iron-hydroxy-phosphate of added ferric iron from domestic wastewater by an alternating aerobic-anoxic process (2014)
-
Understanding of mass transfer resistance for the adsorption of solute onto porous material from the modified mass transfer factor models (2013)
-
Calculation of optimal gas retention time using a logarithmic equation applied to a bio-trickling filter reactor for formaldehyde removal from synthetic contaminated air (2013)
|
559
|
Universiti Teknologi Malaysia |
Assoc. Prof. Dr. Norasikin Othman |
Department of Chemical Engineering, Faculty of Chemical Engineering (FChE) |
Solvent extraction and Emulsion Liquid membrane processes for metal/solute recovery from liquid waste solution.
|
-
PhD in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
-
MEng in Chemical, Universiti Teknologi Malaysia, Malaysia
-
BEng in Chemical Engineering, Universiti Teknologi Malaysia
|
-
Fabrication of polypropylene membrane via thermally induced phase separation as a support matrix of tridodecylamine supported liquid membrane for Red 3BS dye removal (2015)
-
Performance of electrostatic field in continuous demulsification of simulated crude oil emulsion (2015)
-
Recovery of ionized nanosilver by emulsion liquid membrane process and parameters optimization using response surface methodology (2014)
|
558
|
Universiti Teknologi Malaysia |
Assoc. Prof. Dr. Haslenda Hashim |
Process Systems Engineering Centre (PROSPECT) |
Process Modeling, Optimization, and Planning
|
-
PhD in Chemical Engineering, University of Waterloo, Canada
-
MSc in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
-
BEng in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
|
-
Optimal landfill gas utilization for renewable energy production (2015)
-
Energy and emissions benefits of renewable energy derived from municipal solid waste: Analysis of a low carbon scenario in Malaysia (2014)
-
Method for identifying errors in chemical process development and design base on accidents knowledge (2014)
|
557
|
Universiti Teknologi Malaysia |
Assoc. Prof. Azeman Mustafa |
Department of Renewable Energy, Faculty of Petroleum and Renewable Energy Engineering |
-
Membrane for gas and liquid separation
- Membrane for energy application (fuel cell and solar cell)
- Carbon fibre and carbon nanotube
|
-
Phd in Combustion Engineering, The University of Leeds, United Kingdom
-
MSc (Distinction) in Combustion and Energy, The University of Leeds, United Kingdom
-
BSc in Chemical Engineering, The University of Louisiana, United States
|
-
The impact of ZIF-8 particle size and heat treatment on CO2/CH4 separation using asymmetric mixed matrix membrane (2014)
-
Asymmetric mixed matrix membrane incorporating organically modified clay particle for gas separation (2014)
-
Aqueous room temperature synthesis of zeolitic imidazole framework 8 (ZIF-8) with various concentrations of triethylamine (2014)
|
555
|
Universiti Malaya |
DR. WAGEEH EL HADI |
Nanotechnology & Catalysis Research Centre (NANOCAT) |
Organic chemistry, nanostructured design
|
-
PhD in Organic Synthesis, University Of Malaya, Malaysia
-
MSc in Chemistry, University Of Mosul, Iraq
-
BSc in Chemistry, University Of Mosul, Iraq
|
-
Catalytic conversion of biodiesel derived raw glycerol to value added products (2015)
-
Acetylation of salicylic hydrazone: 1,3,4- Oxadiazolines and 1,3,4-Oxadiazepines formation (2015)
-
Correlation of antioxidant activities with theoretical studies for new hydrazone compounds bearing a 3,4,5-trimethoxy benzyl moiety (2015)
|
554
|
Universiti Malaya |
DR. LAI CHIN WEI |
Nanotechnology & Catalysis Research Centre (NANOCAT) |
-
Composite Materials (Photocatalyst, Metal Oxides, Hybrid Materials, Advanced Materials)
- Waste Management (Environmental Pollution Management)
- Semiconductor Materials (Titanium Dioxide, Tungsten Trioxide, Zinc Oxide, Copper Oxide, Iron Oxide)
- Nano Materials (Nano-tubes, Nano-rods, Nano-particles, Nano-wires)
- Coal Energy Technology (Graphene-based catalysts; Cellulose; Carbon-based catalysts; Carbon nanotubes)
- Solar Energy Technology (Hydrogen Fuel Cell, Photoelectrochemical Cell, Photovoltaic Cell, Dye-Sensitized Solar Cell)
|
-
PhD (Engineering), Universiti Sains Malaysia, Malaysia
-
BEng (Hons) in Material Engineering, Universiti Sains Malaysia, Malaysia
|
-
An Overview: Recent Development of Titanium Dioxide Loaded Graphene Nanocomposite Film for Solar Application (2015)
-
Modification of Multi-walled Carbon Nanotubes with TiO2 Nanoparticles for High Photocatalytic Activity (2015)
-
Preparation of High Crystallinity Cellulose Nanocrystals (CNCs) by Ionic Liquid Solvolysis (2015)
|
553
|
Universiti Malaya |
PROF. DR. ANGELINA CHIN YAN MUI |
Institute of Mathematical Sciences, Faculty of Science |
Cohomology of groups, ring theory
|
-
PhD, University Of Queensland, Australia
-
MSc, University Of Malaya, Malaysia
-
BSc. (Hons) University Of Malaya, Malaysia
|
-
Embeddings of generalized Latin squares in finite groups (2015)
-
Non-commutative generalized Latin squares of order 5 and their embeddings in finite groups (2014)
-
Covering finite groups by subset products (2013)
|
551
|
Universiti Malaya |
DR. SITI NURMAYA MUSA |
Department of Mechanical Engineering, Faculty of Engineering |
Production Engineering (Production Economics), plant design, work measurement, operation research
|
-
PhD in Production Economics, Linkoping University, Sweden
-
Master in Manufacturing Management, University Of Nottingham, United Kingdom
-
BSc in Engineering, University Of Wisconsin, United States
|
-
Strategy selection for sustainable manufacturing with integrated AHP -VIKOR method under interval-valued fuzzy environment (2015)
-
Drivers and Barriers Analysis for Green Manufacturing Practices in Malaysian SMEs: A Preliminary Findings (2015)
-
An integrated model for green supplier selection under fuzzy environment: application of data envelopment analysis and genetic programming approach (2015)
|
550
|
Universiti Malaya |
DR. KAZI MD. SALIM NEWAZ |
Department of Mechanical Engineering, Faculty of Engineering |
Heat Transfer, Fluid Mechanics, Industrial Heat Exchanger Design And Fouling Mitigation, Fibre Characterisation, Refrigeration And Airconditioning, Composite Etc.Engineering Sciences (Heat transfer, fluid mechanics, fouling etc.)
|
-
PhD, University Of Auckland, New Zealand
-
MSc, University Of Engineering & Technology, Bangladesh
-
MEng, University Of Auckland, New Zealand
|
-
Synthesis of ethylene glycol-treated Graphene Nanoplatelets with one-pot, microwave-assisted functionalization for use as a high performance engine coolant (2015)
-
Study of mineral fouling mitigation on heat exchanger surface (2015)
-
Heat transfer coefficient of flowing wood pulp fibre suspensions to monitor fibre and paper quality (2015)
|
549
|
Universiti Malaya |
PROF. DR.YATIMAH BINTI ALIAS |
Department Of Chemistry, Faculty Of Science |
- Electrochemistry (Electrosynthesis, Electrodeposition)
- Coordination Chemistry (Supramolecular Chemistry)
|
-
PhD, East Anglia University, United Kingdom
-
MSc, University Of Malaya, Malaysia
-
BSc, University Of Malaya, Malaysia
|
-
Electrodeposition of copper oxide/polypyrrole/reduced graphene oxide as a nonenzymatic glucose biosensor (2015)
-
A hydrothermally prepared reduced graphene oxide-supported copper ferrite hybrid for glucose sensing (2015)
-
Synthesis and characterization of Fe3O4 rose like and spherical/reduced graphene oxide nanosheet composites for lead (II) sensor (2015)
|