570
|
Universiti Teknologi Malaysia |
Dr. Srithar Rajoo |
UTM Centre for Low Carbon Transport in cooperation with Imperial College London (LOCARTIC) |
Interested in all areas of Low Carbon Technology for application in transport. Our current research focuses on internal combustion engine efficiency, specifically related to engine downsizing and waste heat recovery systems.
|
-
PhD in Mechanical Engineering, Imperial College London, United Kingdom
-
MSc in Engineering Management, Universiti Teknologi Malaysia, Malaysia
-
BEng in Mechanical Engineering, Universiti Teknologi Malaysia, Malaysia
|
-
Influence of pulsating flow frequencies towards the flow angle distributions of an automotive turbocharger mixed-flow turbine (2015)
-
Influence of speed and frequency towards the automotive turbocharger turbine performance under pulsating flow conditions (2014)
-
(2014)Novel method to improve engine exhaust energy extraction with active control turbocharger
|
569
|
Universiti Teknologi Malaysia |
Dr. Siti Hamidah Mohd Setapar |
Department of Chemical Engineering, Faculty of Chemical Engineering (FChE) |
Separation processes of pharmaceutical products, neutraceutical studies, and agricultural waste management
|
-
PhD in Chemical Engineering, Longhborough University, United Kingdom
-
Master in Separation Process, Universiti Teknologi Malaysia, Malaysia
-
BSc in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
|
-
New generation Amberlite XAD resin for the removal of metal ions: A review (2015)
-
A new method of extraction of amoxicillin using mixed reverse micelles (2014)
-
Use of supercritical CO2and R134a as solvent for extraction of β-carotene and α-tocopherols from crude palm oil (2014)
|
568
|
Universiti Teknologi Malaysia |
Dr. Rohah A. Majid |
Department of Chemical Engineering, Faculty of Chemical Engineering (FChE) |
Polyurethane waterborne coatings, Polyacrylic coatings, Polymer synthesis, Biopolymers
|
-
PhD in Polymer Technology and Synthesis, Loughborough University, United Kingdom
-
MSc in Chemical Engineering, Longhborough University , United Kingdom
-
BEng of Chemical Engineering (Polymer), Universiti Teknologi Malaysia
|
-
Effects of montmorillonite (MMT) on morphological, tensile, physical barrier properties and biodegradability of polylactic acid/starch/MMT nanocomposites (2015)
-
Development of rigid bio-nanocomposite polyurethane foam for load bearing application: Effect of surfactant composition (2015)
-
Effects of silicone surfactant on the water absorption and surface morphology of rigid palm oil-based polyurethane foam (2014)
|
567
|
Universiti Teknologi Malaysia |
Dr. Mukhlis A Rahman |
Advanced Membrane Technology Research Centre (AMTEC) |
-
Membrane for gas and liquid separation
- Membrane for energy application (fuel cell and solar cell)
- Carbon fibre and carbon nanotube
|
-
PhD in Chemical Engineering, Imperial College London, England
-
MSc in Gas Engineering, Universiti Teknologi Malaysia
-
BEng in Chemical Engineering, Universiti Teknologi Malaysia
|
-
Photocatalytic degradation of nonylphenol by immobilized TiO2 in dual layer hollow fibre membranes (2015)
-
Morphological study of yttria-stabilized zirconia hollow fibre membrane prepared using phase inversion/sintering technique (2015)
-
Efficient reduction of graphene oxide nanosheets using Na as a reducing agent (2015)
|
566
|
Universiti Teknologi Malaysia |
Dr. Mohd Kamaruddin Abd Hamid |
Process Systems Engineering Centre (PROSPECT) / Department of Chemical Engineering, Faculty of Chemical Engineering (FChE) |
Process Integration (Process Design and Controller Design), Process Fault Detection and Diagnosis( Artificial Neural Networks), Process Modeling, Simulation and Control (Matlab and Hysys)
|
-
PhD in Chemical Engineering, Technical University of Denmark, Denmark
-
MENG in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
-
Bach of Chemical Engineering (Hons), Universiti Teknologi Malaysia, Malaysia
|
-
Flexible and operable heat exchanger networks (2013)
-
A model-based methodology for simultaneous design and control of a bioethanol production process (2010)
-
Integration of process design and controller design for chemical processes using model-based methodology (2010)
|
565
|
Universiti Teknologi Malaysia |
Dr. Mohd Hafiz Dzarfan Othman |
Advanced Membrane Technology Research Centre (AMTEC) |
-
Membrane for gas and liquid separation
- Membrane for energy application (fuel cell and solar cell)
- Carbon fibre and carbon nanotube
|
-
PhD in Chemical Engineering, Imperial College London, England
-
MSc in Gas Engineering, Universiti Teknologi Malaysia
-
BEng (1st Class Hons) in Chemical Engineering, Universiti Teknologi Malaysia
|
-
Photocatalytic degradation of nonylphenol by immobilized TiO2 in dual layer hollow fibre membranes (2015)
-
Morphological study of yttria-stabilized zirconia hollow fibre membrane prepared using phase inversion/sintering technique (2015)
-
Design and performance study of hybrid photocatalytic reactor-PVDF/MWCNT nanocomposite membrane system for treatment of petroleum refinery wastewater (2015)
|
564
|
Universiti Teknologi Malaysia |
Assoc. Prof. Zainal Zakaria |
Department of Renewable Energy, Faculty of Petroleum and Renewable Energy Engineering |
-
Transmission and distribution of gas
- Pipeline transportation
- Conventional energy and renewable energy
- Gas engineering, metering and calibration
|
-
PhD in Gas Engineering, Universiti Teknologi Malaysia, Malaysia
-
MEng in Petroleum, Universiti Teknologi Malaysia, Malaysia
-
BEng in Petroleum, Universiti Teknologi Malaysia, Malaysia
|
-
Hardware development of reflection mode ultrasonic tomography system for monitoring flaws on pipeline (2015)
-
Tomographic image reconstruction of monitoring flaws on gas pipeline based on reverse ultrasonic tomography (2014)
-
The use of reflection mode ultrasonic transceiver sensor in pipeline inspection gauge to monitor pipeline internal corrosion (2014)
|
563
|
Universiti Teknologi Malaysia |
Assoc. Prof. Ir. Dr. Sharifah Rafidah Wan Alwi |
Process Systems Engineering Centre (PROSPECT) / Department of Chemical Engineering, Faculty of Chemical Engineering (FChE) |
Process Design and Integration for Resource Conservation for urban and industrial systems
|
-
PhD in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
-
Bach of Chemical Engineering (Hons), University of Machester Institute of Science and Technology, England
|
-
A process integration approach for design of hybrid power systems with energy storage (2015)
-
A retrofit framework for Total Site heat recovery systems (2014)
|
562
|
Universiti Teknologi Malaysia |
Assoc. Prof. Rahmat Mohsin |
Department of Renewable Energy, Faculty of Petroleum and Renewable Energy Engineering |
-
Transmission and distribution of gas
- Pipeline transportation
- Conventional energy and renewable energy
- Gas engineering, metering and calibration
|
-
PhD in Manufacturing and Mechanical Engineering, The University of Birmingham, United Kingdom
-
MSc in Gas Engineering and Management, The University of Salford, United Kingdom
-
BEng in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
|
-
Numerical analysis of wall shear patterns on the external wall of an API 5L X42 natural gas pipe (2015)
-
Mineral carbonation of red gypsum for CO2 sequestration (2014)
-
Assessment of porous carbons derived from sustainable palm solid waste for carbon dioxide capture (2014)
|
561
|
Universiti Teknologi Malaysia |
Assoc. Prof. Noor Shawal bin Nasri |
Department of Renewable Energy, Faculty of Petroleum and Renewable Energy Engineering |
-
Transmission and distribution of gas
- Pipeline transportation
- Conventional energy and renewable energy
- Gas engineering, metering and calibration Renewable CO2 management, Credit Development Mechanism (CDM) Kyoto Protocol Policy, Absorbance gases fuel (ANG)
|
-
PhD in Fuel and Energy, University of Leeds, United Kingdom
-
MSc in Gas Engineering and Management, The University of Salford, United Kingdom
-
BEng in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
|
-
Assessment of porous carbons derived from sustainable palm solid waste for carbon dioxide capture (2014)
-
Effect of biodiesel blends on engine performance and exhaust emission for diesel dual fuel engine (2014)
-
Sulphur poisoning and regeneration of precious metal catalysed methane combustion (2003)
|
