741
|
Universiti Teknologi PETRONAS |
DR WILLIAM PAO KING SOON |
Universiti Teknologi PETRONAS, Block 17 |
Multiphase flow in coupled reservoir geomechanics, computational multiphase flow and heat transfer, finite element method
|
- PhD in Mechanical Engineering by University of Wales Swansea
- PhD by University of Wales Swanse
- Degree in Mechanical Engineering by University of Wales Swansea
|
- Numerical simulation of two–phase separation in a small diameter ratio T-junction: Numerische Simulation der Zweiphasentrennung in einem T-Knoten mit kleinem Durchmesser (2017)
- Numerical investigation of side arm gas volume fraction in two phase T-junction (2016)
- Preliminary numerical simulation of steady-state gas-liquid flow in horizontal T-junction (2017)
- Numerical validation of two-phase slug flow and its liquid holdup correlation in horizontal pipeline (2017)
- Numerical analyses for improved terminal velocity of deep water torpedo anchor (2017)
- Numerical investigation of side arm gas volume fraction in two phase T-junction (2016)
- CO2flow in saline aquifer with salt precipitation (2016)
- Simulation of two phase oil-gas flow in pipeline (2016)
- Simulation of two phase oil-gas flow in T-junction (2016)
|
740
|
Universiti Teknologi PETRONAS |
AP. DR. AZURAIEN BIN JAPPER@JAAFAR |
Centre for Advanced and Professional Education (CAPE), Universiti Teknologi PETRONAS, Level 16, Menara 2, Menara Kembar Bank Rakyat |
Flow Assurance: Waxy crude oil and Waxy crude oil emulsion, Rheology of non-Newtonian fluids, Drag reduction studies, Laminar, Transitional and Turbulent non-Newtonian flow behaviour
|
- PhD in Non-Newtonian Fluid by University of Liverpool
- Master in Computational Fluid Dynamics by Cranfield University
- Degree in Mechanical Engineering / Mathematics by Vanderbilt University
|
- Flow start-up and transportation of waxy crude oil in pipelines-A review
- A new perspective on the measurements of wax appearance temperature: Comparison between DSC, thermomicroscopy and rheometry and the cooling rate effect
- The role and effect of aeration on combined demulsification process for stubborn water-in-oil emulsion from slop oil tank
- The Effect of CO2 on Wax Appearance Temperature of Crude Oils
- Investigation of convective heat transfer coefficient and initial temperature of waxy crude oil on the formation of voids
|
739
|
Universiti Teknologi PETRONAS |
AP. IR. DR. HAMDAN BIN YA |
Universiti Teknologi PETRONAS, Block 17 |
Impact Engineering and Energy Absorption on Structure and FRP Composite Materials Energy Audit and ManagementMechanical Engineering & Design (Pressure Vessel / Bioreactor Design)FRP composite pipe
|
- PhD in Impact Engineering on Composite Pipe (Applied Mechanics) by The University of Manchester
- Degree in Advance Diploma in Mechanical Engineering (B. Eng. Hons) by Institut Teknologi Mara
- Diploma In Mechanical Engineering by Institut Teknologi Mara
|
- Effect of composite layers on partially wrapped Al-glass/epoxy hybrid tube subjected to axial load (2017)
- Comparison of Energy Absorption of Aluminium-composite Tubes Subjected to Axial Loading (2017)
- The effect of fiber angles on energy absorption of 50 % partially wrapped aluminium-composite hybrid tube under axial crushing : Die Wirkung von Faserwinkeln auf die Energieabsorption von 50 % teil-umhülltem Aluminium-Verbund-Hybridrohr unter axialer Stauchung (2017)
- Collapsed mode and specific energy absorption of glass filled polypropylene (GPE) and glass filled polyethylene (GPP) composite pipes under quasi-static axial loading (2016)
- Energy absorption capability of aluminium tube partially wrapped with glass/epoxy subjected to quasi-static loading (2016)
|
738
|
Universiti Teknologi PETRONAS |
AP. DR. FAKHRULDIN BIN MOHD HASHIM |
Universiti Teknologi PETRONAS, Block N3 |
Sub-sea facilities design, Engineering Systems Design, Manufacturing Automation, CAE/CFD, HPHT Multiphase Flow, Topside facility design, Cost enineering
|
- PhD in Computer Aided Engineering by University of Leeds
- MSc in Advanced Manufacturing Systems and Technology by University of Liverpool, UK
- BEng (Mechanical Eng) by Royal Melbourne Institute of Technology, Australia
|
- Computational study and analysis of compact cryogenic separator for high CO2 separation, (2018)
- Development of a hydrate formation prediction model for sub-sea pipeline (2017)
- Time delay estimation using continuous wavelet transform coefficients
- An intelligent optimization–based prediction model for natural gas hydrate formation in a deepwater pipeline (2016)
- Empirical modeling of hydrate formation prediction in deepwater pipelines (2016)
- A prediction model for the natural gas hydrate formation pressure into transmission line
- Prediction of hydrate formation conditions in subsea pipeline with genetic algorithm
|
737
|
Universiti Teknologi PETRONAS |
AP. IR. DR. MOHD AMIN BIN ABD MAJID |
Universiti Teknologi PETRONAS, Block N3 |
Manufacturing Process Optimiztion, District Cooling, Engineering Economic Analysis, Asset Life Study, Plant Asset Maintenance Management
|
- PhD in Mechanical Engineering (Manufacturing) by Universiti Malaya
- Industrial Engineering and Management by Asian Institute of Technology
- Mechanical Engineering by Institut Teknologi Bandung
|
- Computational study and analysis of compact cryogenic separator for high CO2 separation (2018)
- Evaluations of thermocline and half cycle figure of merit of a thermal energy storage tank (2017)
- Supply chain model for gas pipeline (2017)
- Proposed guidelines for welding procedures to ensure quality welding of creep strength enhanced ferritic (CSEF) materials (2016)
- Effect of irreversibility on COP of double effect steam absorption chillers (2016)
|
736
|
Universiti Teknologi PETRONAS |
Associate Professor Dr. Mohammad Shakir Nasif |
Department of Mechanical Engineering, Faculty of Engineering |
Fire & Explosion, Computational Fluid Dynamics, Energy in buildings, Thermofluid
|
- PhD in Mechanical Engineering, University of New South Wales - Australia
- Master of Engineering, University of Technology, Sydney - Australia
- Post Graduate Certificate in Fire Engineering
- Bachelor of Science Engineering in Machines and Equipment
Engineering (General Mechanics)
University of Technology, Iraq
|
- Computational fluid dynamics simulation of blood flow profile and shear stresses in bileaflet mechanical heart valve by using monolithic approach, Simulation Journal, (2018) 94 (2), 93–104.
- Numerical Investigation of Smoke Contamination in Atrium Upper Balconies at Different Down Stand Depths, Journal of Building Simulation, 10 (3) (2017) 365-381.
- Measurements of Translational Slug Velocity and Slug Length Using an Image Processing Technique, Flow Measurement and Instrumentation 50 (2016) 112–12
- Numerical Investigation of Slug Characteristics in a Horizontal Air/Water and Air/Oil Pipe Flow, Progress in Computational Fluid Dynamics, an International Journal, (2017) DOI: 10.1504/PCFD.2017.10006061.
|
587
|
Universiti Teknologi PETRONAS |
PROF. DR. AZMI MOHD SHARIFF |
Department of Chemical Engineering, Faculty of Engineering |
Adsorption Processes, CO2 Separation Processes and Process Safety
|
-
PhD in Chemical Engineering, University of Leeds, England
-
MSc in Process Integration, University of Manchester Institute of Science and Tecknology, England
-
Beng in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
|
-
Qualitative Assessment for Inherently Safer Design (QAISD) at Preliminary Design Stage (2009)
-
On-line At-Risk Behavior Analysis and Improvement System (e-ARBAIS) (2008)
-
Inherent Safety Index Module (ISIM) to Asses Inherent Safety Level during Preliminary Design Stage, Process Safety and Environmental Protection (208)
|
586
|
Universiti Teknologi PETRONAS |
AP. DR. YEONG YIN FONG |
Department of Chemical Engineering, Faculty of Engineering |
Development of Membrane Materials (inorganic, polymeric and mixed matrix) for Gases Separation
|
-
Deg in Chemical Engineering, Univesiti Sains Malaysia, Malaysia
|
-
Capture of bulk CO 2 from methane with the presence of heavy hydrocarbon using membrane process (2014)
-
Temperature and pressure dependence of membrane permeance and its effect on process economics of hollow fiber gas separation system (2013)
-
Thermal induced structural rearrangement of cardo-copolybenzoxazole membranes for enhanced gas transport properties (2012)
|
584
|
Universiti Teknologi PETRONAS |
ASSOC. PROF. MAIZATUL SHIMA SHAHARUN |
Research and Innovation Office |
Separation Process (Adsorption, membrane processes, absorption), Catalyst And Reaction Engineering (Synthesis of Catalyst, CO2 Hydrogenation to Methanol, Photocatalysis)
|
-
PhD in Chemical Engineering
-
MSc in Chemical Process Technology
-
BSc in Chemistry
|
-
Hydroformylation of 1-octene using rhodium-phospite catalyst in a thermomorphic solvent system (2010)
-
Characterization of adsorbent developed from rice husk: Effect of surface functional group on phenol adsorption (2010)
-
Solubility of carbon monoxide and hydrogen in propylene carbonate and thermomorphic multicomponent hydroformylation solvent (2008)
|
581
|
Universiti Teknologi PETRONAS |
ASSOC. PROF. DR. LAU KOK KEONG |
Department of Chemical Engineering, Faculty of Engineering |
-
Process Modelling and Scale-up, computational fluid dynamics and membrane separation
|
-
PhD in Chemical Engineering, Universiti Sains Malaysia, Malaysia
-
BEng in Chemical Engineering, Universiti Teknologi Malaysia, Malaysia
|
-
Model development for hydrodynamic study of fluidized bed gasifier for bioCO2 Capture from Natural Gas using Membrane Separation System: Process Simulation, Parametric Analysis and Joule Thompson Effect (2011)
-
Removal of CO2 from natural gas using membrane separation system : Modeling and process design (2010)
-
Kinetic adsorption of CO2/CH4 mixture using 13x Zeolite (2010)
|